How to Install New ATV Seat Cover?

Table of Contents

Like your bike tires should be in a first state to prevent dirt, your bike seat is also essential since it provides grip to keep you glued to the motorcycle in excrement acceleration instances. The seat cover is supposed to keep you glued on the bike.

After constant use of the seat, it loses its grip, and the cover gets chewed up by the sun. Slippery seat covers can make you slide off the back of the bike when starting. You should ensure your seat cover has the right grip on all occasions. Below is the procedure of how to install ATV seat cover in an easy way.

Read More – How to Repair ATV Seat Cover?

How to Install ATV Seat Cover in 6 Step

1st Step –

The very first move is to pick up your tools, including your recently acquired seat cover, a plain-head screwdriver, old seat, needles, scissors, and a 1/4-inch hand or air-powered staple device.

2nd Step –

Start by prying the screwdriver with the old staples and remove the old cloth from the seat. Upon removing all nails, cut the older cover, switch over the seat, and inspect the padding.

3rd Step –

It’s time to install your seat cover. Covers often have a stitch upfront section that slides over the seat face to match the cover from the beginning. After straight, tweak the seatback until the underside faces up and put 3 staples over each other’s cover. This will maintain the cover when focusing on the next moves.

4th Step –

You should staple the seat cover successively. Take out and back on the cover every 6 inches, add two or three plugs on the seat’s left and right as you go down evenly. This helps the folds in the new seat cover as you continue. Flip over the seat and check the cover if you put a new set of wrinkles and lighten but pull the cover as you leave. Break and staple again to help tighten the sheet.

5th Step –

If you hit the back of the seat, the work will get complicated. You will have to wave in the fabric to get the covers to the seat’s various curves and angled corners by adding a new staple every half inch or so. This makes the top surface smooth, wrinkle-free when you walk along any circular tip. If you’ve completed the bench’s back, go forward and apply a staple around the bench per inch. Now, the cover won’t hop and be relaxed on your seat.

6th Step –

Now, the seat cover has effectively been installed on your seat by smoothing out all of your folds, grab the scissors and cut out excess cloth at the base of your seat. The work is done; the newly covered seat can be moved back into the machine and taken for a spin.

A nice trick that will help you during the ATV seat cover install is leaving the seat cover in a warm place or the sun before putting it in place and stalling it. By going it in such conditions, you will be making that gripper material more flexible, which will help you during installation.

Special attention must be given to the nose and tail of the seat. When wrapping the two up, you must be careful to prevent any wrinkles from showing up on the outer part of the seat. You should also ensure you have not caused any bunching on the seat cover as you warp them up.

Installing a cover seat might be overwhelming, but the results are worth it. Gripping covers not only make you comfortable but also safe. Get yourself a gripping seat cover.

Check out the following video to learn more visually –

Video Credit – PowerModz

Video Credit – Skills USA

Image & Information Credit – 

Information

More from this category